Caple C864I - Advanced Cooking Features

13
Booster function
The booster function [ P ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones work for 5 minutes with an ultra-high power.
The booster is used for example, to rapidly heat up big quantities of water.
• Start up / Stop the booster function:
Action Control panel Display
Zone selection Press key [ 0 ] from the zone [ 0 ] and control light on
Start up the Booster Press key [ ] [ P ] during 5 min
Stop the Booster Slide on the “SLIDER“ [ P ] to [ 0 ]
Or press [ ] [ 9 ]
• Power management:
If the selected heating levels for both zones exceed the maximum available amount of power,
the power management function will automatically reduce the power from one of these zones.
The display of this zone will blink first; the level is then automatically reduced to the highest
suitable position.
Heating zone selected The other heating zone: (example: power level 9)
[ P ] is displayed [ 9 ] goes to [ 7 ] depending on the type of zone
Timer
The timer can be used with all heating zones simultaneously and with different time settings
(from 0 to 99 minutes) for each heating zone.
• Setting and modification of the cooking time:
Example for 16 minutes at power 7:
Action Control panel Display
Zone selection Press display [ 0 ] selected [ 0 ] and control light on
Select the power level Slide on the “SLIDER“ to [ 7 ] [ 7 ]
Select « Timer » Press display [ CL ] [ 00 ]
Set the units Slide on the “SLIDER“ to [ 6 ] [ 0 fixed ] [ 6 blinking ]
Confirm the units Press display [ 06 ] [ 0 blinking ] [ 6 fixed ]
Set the tens Slide on the “SLIDER“ to [ 1 ] [ 1 blinking ] [ 6 fixed ]
Confirm the tens Press display [ 16 ] [ 16 ]
The time is confirmed and the cooking starts.
• To stop the cooking time:
Example for 13 minutes at power 7:
Action Control panel Display
Zone selection Press display [ 0 ] selected [ 0 ] and control light on
Select « Timer » Press key [ 13 ] [ 13 ]
Deactivate the units Slide on the “SLIDER“ to [ 0 ] [ 1 fixed ] [ 0 blinking ]
Confirm the units Press display [ 10 ] [ 1 blinking ] [ 0 fixed ]
Deactivate the tens Slide on the “SLIDER“ to [ 0 ] [ 0 blinking ] [ 0 fixed ]
Confirm the tens Press display [ 00 ] [ 00 ]