12
OPERATION MODE
Standard configuration:
Standard configuration requires all cooker hoods radio control - system to be
provided with the same transmission code. In the event two cooker hoods radio
control system are installed in the same room or nearby, each system may affect the
operation of the another. Therefore, the code of one radio control system must be
changed.
Generating a new transmission code:
The radio control system is provided with preset codes. Should new codes be
required, proceed as follows: Press simultaneously buttons:
for two seconds. When LEDs light on, press buttons:
(within 5 seconds). Leds flashing 3 times indicate the procedure is completed.
WARNING:
This operation deletes permanently the preset codes.
Learning the new transmission code:
Once the transmission code is changed in the radio control unit, the electronic
central unit of the cooker hood must be made to set the new code in the following
way: Press the main power-off button of the hood (fig. 11) and then restore power
to the electronic control unit. Within the next 15 seconds, press the Light Button
to synchronise the central unit with the code.
DIMMABLE LIGHTS FUNCTION
This function provides for lights dimmability, ranging from 20% to 100%,
by continuously pressing the light key on the remote control.
Functions are the following:
- Hood light off - press the light key - light on at 100%.
- Light on at 100% - press the lightkey - light off.
- Light on at 100% - continously press the light key - brightness reduction.
To Next Page
Loading...
