Instruction manual COR540SL18
Please keep this instruction manual for future reference
CLEANING AND MAINTENANCE
Careful maintenance ensures smooth operation and long-lasting performance.
Special care must be taken with the grease filter.
To access the filter, proceed as follows:
In the Chapter - OPENING THE PANEL.
Remove the grease filter using the special handle.
To replace the grease filter after cleaning, fulfil the same operation in reverse order.
To remove the carbon filter, if installed, follow the same steps as the grease filter.
The carbon filter is located immediately above the grease filter.
Warm water and neutral detergents are recommended to clean up the appliance, while abrasive
products should be avoided.
If the power cord is damaged, a qualified person must replace it.
It is possible to open the grease filter cover panel pulling it as shown in fig. 1.
The panel is fixed with three magnets, there are two safety cables to be released to remove the
panel from the product.
For proper operation, it is recommended to install the product at a maximum distance, from the
floor level, of 2000 - 2100mm.
To Next Page
Loading...
