Caple CR 9207 - Anti-Tilt Bracket Installation (Model CR 1207)

13
Anti-Tilt Bracket - Model CR 1207
Important!
Torestraintheapplianceandpreventittippingaccidentally,tabrackettoitsrear
toxitsecurelytothewall.
To t the anti-tilt bracket:
1. After you have located where the cooker is to be positioned, mark on the wall the place
where the two screws of the anti-tilt bracket have to be tted.
 Please follow the indications given in g. 2.11.
2. Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.
 Important!
 Before drilling the holes, check that you will not damage any pipes or electrical
wires.
3. Loosely attach the anti-tilt bracket with the two screws supplied.
4. Move the cooker to the wall and adjust the height of the anti-tilt bracket so that it can
engage in the slot on the cooker’s back, as shown in g. 2.11.
5. Tighten the screws attaching the anti-tilt bracket.
6. Push the cooker against the wall so that the anti-tilt bracket is fully inserted in the slot
on the cooker’s back.
Fig. 2.11