8
2 - Location
FOR THE INSTALLER
500 mm
650 mm
450 mm
200 mm
650 mm
500 mm
450 mm
200 mm
The appliance is designed and
approved for domestic use only
and should not be installed in a
commercial, semi commercial or
communal environment.
Your product will not be guaranteed
if installed in any of the above
environments and could affect
any third party or public liability
insurances you may have.
If the cooker is installed adjacent
to furniture which is higher than the
gas hob cooktop, a gap of at least
200 mm must be left between the
side of the cooker and the furniture.
The furniture walls adjacent to the
cooker must be made of material
resistant to heat.
The veneered synthetic material
and the glue used must be resistant
to a temperature of 90°C in order
to avoid ungluing or deformations.
Curtains must not be fitted
immediatly behind appliance or
within 500 mm of the sides.
It is essential that the cooker is
positioned as stated in (Figs. 2.1a
- 2.1b).
This cooker has class “2/1” overheating protection so that it can be installed next
to a cabinet.
The appliance may be installed in a kitchen, Kitchen/diner or a bed sitting room, but
not in a room or space containing a bath or a shower.
The appliance must not be installed in a bed-sitting room of less than 20 m
3
.
The cooker must be installed
by a qualified technician and
in compliance with local safety
standards.
If the cooker is located on a
pedestal it is necessary to provide
safety measures to prevent falling
out.
Fig. 2.1b
Fig. 2.1a
Model CR 9207
Model CR 1207
To Next Page
Loading...
