Car and Driver CDC609 - 3. Operations; 3-1 Turning the device on;off

3. Operations
3-1 Turning the device on/o
The device will automatically turn on when you start your car’s engine, and automatically turn o
when you shut o your car.
To manually turn your Dash Cam on/o, press and hold the Power button for 1 second.
LED
Indicators
LED Indicators on the device
Description
Restarting the Dash Cam
Occasionally, you may need to perform a hardware reset when the Dash Cam stops responding or if
it appears to be “frozen” or unresponsive. To restart the Dash Cam, press and hold the Power button
until the system powers o. Press the Power button again to turn the Dash Cam on.
If the system does not shut down by holding the Power button, you may do a forced reboot by
inserting a paper clip into the “RESET” button hole on the device.
REC indicator
REC
indicator
When you turn on the device, the REC
indicator glows blue. While recording,
the REC indicator flashes blue to indi-
cate that recording is in progress.
When this device is connected to
an external power supply, the power
indicator glows red.
Power
indicator
Power indicator
6 EN