8555-M313-O1 Rev H • 204 Installation & Technical
6
INSTALLATION, CONT.
Figure No. 2
Batteries
The 204 indicator can use 6 "C" size Alkaline, Ni-Cad or NiMH batteries (not included). You
must first obtain and install batteries in the 204 before operations can begin. The batteries are
contained in a battery holder inside the indicator. Access is via a removable panel on the back
of the indicator.
The 204 can operate for 200 hours of continuous use when using alkaline batteries or with fully
charged Ni-Cad or NiMH batteries, 50 hours of continuous use.
NOTE: The 204 indicator can be operated from Alkaline, Ni-Cad or NiMH batteries
or from an AC power adapter. All six (6) batteries must be of the same type. They
must all be Alkaline, all Ni-Cad or all NiMH. DO NOT mix Alkaline and Ni-Cad or
NiMH batteries.
CAUTION! The AC power adapter is also used to recharge the batteries, when the
204 is operated from Ni-Cad or NiMH batteries. DO NOT connect the AC power
adapter to the 204 if using alkaline batteries. Also, when using alkaline batteries,
make sure the niCAd setup option is disabled (set to 0). Refer to Setup and
Calibration or Setup Review.
Battery Door
Serial I/O
Thumb
Screw
Ground Lu
Load Cell
12 VDC
To Next Page
Loading...
