Cardinal 210 User Manual

22
SETUP AND CALIBRATION, Cont.
PUO= (Power-Up Zero Feature)
Press the
ENTER
key to show the current value. If the setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise, using the numeric keys,
0/NO
or
1/YES
, enter the new
setting, then press the
ENTER
key to save it.
PUO = 1 (Yes) PUO = 0 (No)
Automatic Re-Zero on Power-Up No Re-Zero on Power-Up
td= (12 or 24 Time Format) -
Model 210 Only
Press the
ENTER
key to show the current value. If the setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the numeric keys to select the format (12 or 24 hour)
of the Model 210 clock operation, then press the
ENTER
key to save it. Note that in the 24 hour
format, 12 is added to all times after noon, i.e. 3 PM would be 1500.
td = 12 td = 24
12 hour clock (3PM displays 3:00) 24 hour clock (3PM displays 15:00)
d oUt= X,Y (Digital Output) -
Model 210 Only
Press the
ENTER
key to show the current value. If the setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the numeric keys to select the X,Y values for the
digital output, then press the
ENTER
key to save it.
d out= X, Y
where: X = State below cutoff (0 = LOW, 1 = High)
Y = Preset Number or Checkweigher Mode
0, 0
or
0*
Digital Output is disabled
0, 1
or
1*
Low State before cutoff with 1 active Preset
0, 2
or
2*
Low State before cutoff with 2 active Presets
0, 3
or
3*
Low State before cutoff with 3 active Presets
1, 1
High state before cutoff with 1 active Preset
1, 2
High state before cutoff with 2 active Presets
1, 3
High state before cutoff with 3 active Presets
0, 4
or
4*
Low State before cutoff on Checkweigher Mode
1, 4
High state before cutoff on Checkweigher Mode
*
It is not necessary to enter the leading zero (0) for X values on selections. The program will
assign a zero (0) to the X value if only one (1) number is entered.
SLEEP= (Sleep Mode Feature) -
Models 205 and 210 Only
The Sleep Mode feature conserves battery power when the indicator remains unused for a
selected period of time. With the feature enabled, the load cell excitation will be reduced and the
display will be blank.
Press the
ENTER
key to show the current status of this feature. If a number other than 0 is shown,
this feature is selected and the number shown corresponds to the number of minutes of a stable
zero weight reading before the indicator enters the sleep mode. If the setting displayed is
acceptable, press the
ENTER
key again to save it. Otherwise, use the numeric keys to enter a
new value (0 to 10) then press the
ENTER
key to store the new setting. Note that entry of a 0
disables this feature.

Cardinal 210 Specifications

General

Brand	Cardinal
Model	210
Category	Accessories
Language	English