8200-M564-O1 y 225 Check Weigher
Page 7
RE-INSTALLING THE REAR PANEL
After all terminations have been made;
1. Remove the excess cable from the instrument enclosure and securely tighten each of
the cable gland connectors.
y Do not over-tighten these connectors but make certain they are snug.
y DO NOT USE TOOLS! Finger-tighten only!
2. Ensure any unused gland connectors are plugged and replace the rear panel.
3. Secure the rear panel with the 14 acorn nuts removed earlier.
4. Follow a diagonal pattern when tightening the acorn nuts.
To Next Page
Loading...
