11
Hex Format to Transmit - 2H 34H 33H 34H 3H
Equivalent Computer or Terminal Keys to press - Ctrl B 4 3 4 Ctrl C
KeyCommand - 5
Equivalent Keyboard Key - TARE
Function - Enter a Tare weight value
Serial Command Format - STX5xxxxxxCKsumETX
(xxxxxx = the tare weight value)
Hex Format to Transmit - 2H 35H xH xH xH xH xH xH
1
zzH
2
3H
Equivalent Computer or Terminal Keys to press - Ctrl B 5 xxxxxx zz
3
Ctrl C
KeyCommand - 6
Equivalent Keyboard Key - BAR
Function - Enter the Bar Graph Starting (60) and Stop (61)
weight values
Serial Command Format - STX60xxxxxxCKsumETX
(xxxxxx = the Bar Graph Starting Weight)
STX61yyyyyyCKsumETX
(yyyyyy = the Bar Graph Stop Weight)
Hex Format to Transmit - 2H 36H 30H xH xH xH xH xH xH
1
zzH
2
3H
(Start weight command)
2H 36H 31H yH yH yH yH yH yH
2
zzH
2
3H
(Stop weight command)
Equivalent Computer or Terminal Keys to press - Ctrl B 6 0 xxxxxx zz
3
Ctrl C
(Start Weight command)
Ctrl B 6 1 yyyyyy zz
3
Ctrl C
(Stop Weight command)
NOTE: This command will not change from the PWC to Bar Graph mode in the display. It must be
manually selected.
KeyCommand - 7
Equivalent Keyboard Key - PRESET
Function - Enter the Preset or Trim weight value for one or all
eight of the preset weight comparators
Serial Command Format - STX7nxxxxxxCKsumETX
n = the preset or trim weight comparator number
(see below).
(xxxxxx = the weight value for the corresponding
preset number)
Hex Format to Transmit - 2H 37H nH xH xH xH xH xH xH
1
zzH
2
3H
Equivalent Computer or Terminal Keys to press - Ctrl B 7 n xxxxxx zz
3
Ctrl C
Preset and Trim values for “n.”
Note values for “n” are in HEX.
1 set preset 1 7 set preset 4 D set preset 7
2 set trim 1 8 set trim 4 E set trim 7
3 set preset 2 9 set preset 5 F set preset 8
4 set trim 2 A set trim 5 G set trim 8
5 set preset 3 B set preset 6
6 set trim 3 C set trim 6
NOTE: This command will not change from the Bar Graph to PWC mode in the display. It must be
manually selected.
KeyCommand - 8
Equivalent Keyboard Key - none
Function - Initiates an inquiry (ENQ) of the bi-directional I/O
port. This command will cause the displayed
weight to transmit out the serial I/O port.
To Next Page
Loading...
