4
3.0 UNPACKING, INSTALLATION AND
PREPARATION FOR USE
3.1 UNPACKING
Inspect the scale for any signs of damage due to shipping such as loose
screws or exterior dents and scratches on the covers and case. Keep
carton and packing for return shipment of scale if necessary. It is the
responsibility of the purchaser to file all claims for any damages or loss in
transit incurred, unless this responsibility has been accepted by the Seller
in its proposal.
3.2 PLACEMENT
Place the scale on a stable, vibration-free location away from direct
sunlight and away from any rapidly moving air source.
CAUTION!!! DO NOT place the scale on any unstable
cart, stand or table. The scale may fall causing injury to
the operator, and seriously damage the scale, or proper
operation of the scale may be inhibited.
3.3 LEVEL ADJUSTMENT
Before mounting the commodity tray onto the scale, level the scale if
necessary by adjusting the four legs on scale bottom, up or down, until the
bubble in the level gage located on the top cover is centered as shown in
the illustration below. After level is achieved, lock legs in place by
tightening lock nuts on legs against the scale bottom.
Adjusting
Legs
(on bottom
of scale)
Leveled
Not Leveled
To Next Page
Loading...
Need help?
General