4. GETTING STARTED
4.1 GENERAL FUNCTIONS
Power ON / OFF Press “IC” for 2 seconds
ON: 3 BLUE ashes + Ascending tone
OFF: 3 RED ashes + Descending tone
Volume Tap “V+” or “V-” to adjust and set volume of
current audio source
Mute Tap “V+” and “V-” simultaneously
Battery Check In Standby, press “V+” for 2 seconds:
• BLUE LED = Full charge
• PURPLE LED = Half charge
• RED LED = Almost empty
Voice Menu In standby, press “MM” and “IC” simultaneously
for 5 seconds and follow the audio instructions
(see section 4.5)
Enable / Disable
VOX (For Intercom
calls only)
In standby, press “V+” and “V-” simultaneously
for 2 seconds
ENABLED: Blue ash for 2 seconds
DISABLED: Red ash for 2 seconds
Enable/Disable
Click-to-Link (CTL)
(Enabled by default)
Via the Voice Menu or via the Cardo Community
Enable/Disable
Spoken Status
Announcements
(Enabled by default)
Via the Voice Menu or via the Cardo Community
4.2 STATUS LIGHTS
None scala rider is OFF
1 BLUE ash every 3 seconds Standby mode
No active audio sources
2 BLUE ashes every
3 seconds
Active mode – Call in progress / music
or other audio source is ON
1 RED ash every 3 seconds Standby mode – Battery is low
2 RED ashes every 3 seconds Active mode – Battery is low
Solid RED Charging
4.3 AUDIO SOURCES AND PRIORITIES
If two connected audio sources try to play audio simultaneously, your
scala rider automatically determines which audio source to play
through the speakers based on the priority of the connected devices.
Higher Priority
1. Mobile Phone audio or GPS instructions*
2. Intercom / Click-to-Link
3. A2DP (Stereo Bluetooth) audio
4. FM Radio (Built-in)
5. AUX (for corded connection i.e. Music Players)
* GPS instructions from Smartphone GPS Apps are
prioritized like A2DP audio
Lower Priority
For example:
• Incoming mobile phone calls interrupt ongoing intercom calls
• Incoming intercom calls will interrupt ongoing A2DP music
• Intercom and Click-to-Link calls have the same priority. So
Click-to-Link calls will not interrupt any Intercom call in progress,
and vice-versa.
NOTE:
A2DP audio priority can be congured to be higher than
Intercom audio priority via the Cardo Community (see section 4.4).
6
| scala rider
®
Q1 / Q1 TeamSet™
To Next Page
Loading...
Need help?
General
