Carel EVD4 - I.VI Modifying the parameters

33
ENGLISH
EVD
4
+030220227 - rel. 2.1 - 12.06.2008
I.V Loading the data
Pressing will open a dialogue box to read a fi le with the extension *.CFG:
choose a fi le and press
, all the data will be displayed in the various windows of the
EVD400UI program.
To transfer the data to the EVD
4
press , the function in this case has no action
I.VI Modifying the parameters
To modify a numerical parameter:
• check the box containing the value of the parameter
• click the right mouse button
• set the new value
• ENTER
To reverse the value of a digital parameter (red or green rectangle):
• check the box containing the value of the parameter
• click the right mouse button
Meaning of the red or green rectangle:
- GREEN = FALSE or OFF or 0 or DISABLED, in relation to the meaning of the reference parameter
- RED = TRUE or ON or 1 or ENABLED, in relation to the meaning of the reference parameter
if the
checkbox is selected, the data is sent to EVD
4
immediately after having been
modifi ed, otherwise, after having modifi ed all the required data, press
I.VII Confi gurations available
The software used to install EVD4_UI is available in the following confi gurations:
- “EVD4_UI Address”, to set the address of the EVD
4
- “EVD4_UI Key”, to program the key
- “EVD4_UI Stand Alone” to program the stand-alone EVD
4
- “EVD4_UI MCH2” to program the EVD
4
with µC
2
- “EVD4_U positioner” to use the EVD
4
as a positioner with 4 to 20 mA or 0 to 10 Volt
This box is used to set the Driver+Valve system confi guration values.
These parameters should be set and checked before activating the unit.