Carestream Dryview 6850 - Imager Passcode

Using and Maintaining the Imager
2010-11-04 2G8647 2-7
– Enter the current time and select daylight savings
– Review the date/time information
• Set up the film
– Unlock the film drawers
– Load the film
– Calibrate the film
• Configure the network
– Enter the network name
– Enter the Imager IP address
– Enter the subnet mask
– Enter the gateway address
– Review the network information
• Configure CARESTREAM Remote Management Services
• Edit the modality information/parameters
• Save/backup the configuration information
• Exit the Installation Assistant
Imager Passcode
Certain operations through the touch screen require a passcode to be
entered. The Imager comes with a default passcode of 123456. This
passcode can be changed through the touch screen by selecting
Utilities>Service>Change passcode from the Main Screen.