2010-11-04 2G8647 4-1
4
Adding a Modality and
Configuring Modality Image
Quality
Introduction
After the Imager is installed, you can later configure it to print images
from additional modalities. To get the best print from a modality, the
Imager must be configured for each individual modality. The
configuration can be done either automatically or manually.
Adding a Modality
After the Imager has been placed into service, you can later configure it
to print images from additional modalities. To add a modality, do
“Configuring Modalities Automatically”.
Configuring Modalities Automatically
When you print to the Imager for the first time, the Imager will
automatically attempt to identify the modality and auto-configure itself
for the modality.
IMPORTANT: You must have the local panel passcode to perform this
procedure.
1. Send a print request from the modality to the Imager.
The message "A new modality has printed to this imager, do you
want to configure it now?" will appear on the touch screen.
NOTE: If the message does not appear on the touch screen, select
Utilities>Configuration>Installation assistant, and proceed to
step 3.
2. Touch Ye s.
3. Select the modality to be configured from the list.
NOTE: You should also decide on a screen name for the modality. This name
will be used only on the Imager touch screen to identify the modality.
To edit the name, touch Edit.
4. Touch Select.
5. Select the sorter bin that prints from this modality will go to.
6. Touch OK.
To Next Page
Loading...