Carlson BRx7 - Page 48

48 | Page
BRx7 User Manual
WebUI (connued)
NMEA Message
(connued)
Refer to Table 3‐3 for NMEA Message elds and descripons:
Table 3‐3: NMEA Message Fields and Descripons
Field Descripon
NMEA Log Stare the NMEA or binary messages that
are turned on to the internal memory of the
receiver or to an SD Card.
First Storage Select if NMEA, binary, or Athena logs should
be stored to the internal memory of the
receiver or to an SD card.
Athena Log Record raw data for converng to Rinex and
post‐processing. lf “Yes” is selected, the
following dialogue will display: Access the
Rinex converter using the following hyperlink:
hps://www.hemispheregnss.com/rmware-soware/
Point Name Choose a name for the point that is occupied.
Antenna
Height
Type the height of the antenna in meters.
Note: Older versions of rmware required
millimeters (mm) as seen in the image. Please
refer to the unit listed to the right side of the
eld.
Pdop
Threshold
Data will not be logged if the Pdop of the
receiver exceeds the user dened value (3.5 is
the default value and can be changed).
Interval Log data at intervals of 30s, 15s, 5s, 1Hz, 2Hz,
5Hz, or 10Hz.