Carlson BRx7 - BRx7 Troubleshooting Common Issues

56 | Page
BRx7 User Manual
Troubleshoong
Troubleshoong Table A‐1 provides troubleshoong ps for the BRx7.
Table A‐1: Troubleshoong
Issue
Receiver fails to power
Random data from WebUI or
BRx7 Direct Link mode
Possible Resoluon
• External power is low.
• Check charge on external baery
and the fuse on the power cable, if
applicable.
• Internal power: Check charge on
internal baery.
• Check all power cables and pins.
• Try other baeries or cables.
• Make sure to hold the power
buon down for a minimum of one
full second to turn on.
• Ensure the baery is installed with
contacts pointed in the correct
direcon.
• Verify the messages selected in
the output messages in the WebUI
match what you desire.
• Verify the baud rate sengs match.
Potenally the volume of data re-
quested to be output could be higher
than the current baud rate supports.
Try using a higher baud rate for com-
municaons.