SP5014TRX SERVICING BELTS
32
Replacing V-Belt
If the belt tension was adjusted, the engine
slide lock will also have to be adjusted. This
locks the engine in the disengaged position
so that the cutter wheel will not accidentally
engage. When adjusting the engine slide
lock, turn the clevis clockwise to shorten the
length of the engine slide lock when the
engagement linkage was lengthened. The
engagement linkage would be lengthened to
put more tension on the belt. Lengthen the
engine slide lock if the engagement linkage
was shortened.
Replace hydraulic pump making sure the
insert is in place.
Retighten all five belt-keepers when the belt
tension has been adjusted. There are two belt
keepers on the jackshaft sheave. The beehive
has two belt keepers inside it, one on top and
one on bottom. The last belt keeper is beside
the beehive.
REPLACE THE RUBBER INSERT
WHEN REATTACHING THE PUMP
BELT KEEPERS
To Next Page