Carrier 09VE - Handling Units Using Sling Stops Fixed Underneath: Special Units; Transport; 6 Storage

5 - INSTRUCTIONS FOR LIFTING AND TRANSPORTATION
5.2 - Handling units using sling stops xed underneath: special units
e.g.: C5M, copper ns, STAINLESS STEEL pipe wiring bundles, ATEX, STAINLESS STEEL casing.
Textile slings only
Yellow "Lifting instructions" sticker
Slings
Sling stop
x6 x8 x10 x12 x14 x16 x18 x20
W mm 3390 4540 5690 6840 4600 4600 6900 6900
H mm 4100 4100 5000 6000 4100 4000 6100 6100
As the lifting mode is related to the weight of the unit, it is essential to refer to the dimensional drawing for the unit ordered.
5.3 - Transport
■ Do not allow any disruption to the ow
■ Follow the handling instructions afxed to the packages
■ Follow the lashing instructions in the document provided
■ Do not stand on the packages
■ Do not place anything on top of the packages
■ Strap the packages onto the deck of the truck
■ Only textile straps are authorised (lifting and coupling)
■ Use the dedicated option for container transport
6 - STORAGE
■ Store the units at a temperature of between -40 and +60°C (temperature range for standard units). For options, see the relevant
description.
■ Protect the units against impacts and ensure that they only support their own weight.
■ Place the units on rm, at and level ground. For storage in very windy areas, afx the unit to the ground using straps or cables.
■ Leave the blanking trim for the pipes in place before connecting the unit.
■ For long-term storage (over 3 months), ll the exchanger with an inert gas and seal the pipes using caps. This is necessary to
prevent the formation of condensation and oxidation. Warning: do not exceed the maximum operating pressure indicated on the
data plate.
■ For long-term storage, it is recommended to place the units in an area protected from adverse weather conditions.
7