Carrier 30XA - Unit Start;Stop, Mode Selection, and User Login

10
Information message box
The information displayed in the status bar at the bottom of
the screen includes relevant messages regarding the current
user action.
All screens presented further in this manual may display the
following messages:
MESSAGE STAT US
COMMUNICATION FAILURE! Equipment controller did not respond while
reading the table content.
ACCESS DENIED! Equipment controller denies access to one of the
table data blocks.
LIMIT EXCEEDED! The value entered exceeds the table limits.
Save changes? Modications have been made. The exit must be
conrmed by pressing Save or Cancel.
HIGHER FORCE IN EFFECT! Equipment controller rejects Force or Auto
command.
4.3 - Start/Stop screen
The Start/Stop screen allows users to select the operating
mode of the unit.
4.3.1 - Unit start-up
With the unit in the Local off mode, press the Start/Stop
button to display the list of operating modes and select
the required mode.
NOTE: When entering the menu, please note that the currently
selected item corresponds to the last running operating type.
4.3.2 - Unit stop
In order to stop the unit, press the Start/Stop button
Conrm Stop or return
to the previous screen by pressing the Back button
Once the unit has been stopped, the Synoptic screen will be
displayed (see also section 4.2.2).
Shows the last
selected mode
4.3.3 - User Login screen
The User Login screen allows the user to select the language
of the controller, change the system of measurement
(imperial or metric) and enter a password to gain access to
more control options (default password = 11).
The User Login screen can be accessed by pressing the Log
button in the upper-right corner of the screen (see also
section 4.2.2).
4.4 - Main menu
The Main menu provides access to the main control
parameters, including general parameters, inputs and outputs
status, etc.
In order to access the menu, press the Main menu button
located in the upper-left part of the Synoptic screen
(see also section 4.2.2).
Specic unit parameters table/menu can be accessed by pressing
the icon corresponding to the desired category. In order to go back
to the Synoptic screen, press
1. Cursor indicating the selected language
2. Logged-in button
3. Logged-o button
4. System of measurement selection: Metric/Imperial
5. Password dialog box
Once all the changes have been made, press to save or
to cancel changes.
NOTE: Password validation is effective only after pressing
the Logged-in button.