GB-12
Do not adopt configurations other than
those indicated above, as this may com-
promise the correct operation of the unit. In
particular, avoid operating the unit with just
one aperture.
Predisposition of the unit for circular
front outlets
The unit is supplied with a front enclosure
panel with 8” diameter circular cut-outs.
Before removing the cut-outs, cut the insu-
lation on both sides of the panel with a suit-
able knife. This facilitates opening and pre-
vents damage to the insulation.
After removing the cut-outs, make certain
that the insulation covers all the parts in
steel sheet.
After removing the cut-outs, replace the
front panel of the unit.Also using the screws
supplied.
To Next Page
Loading...
