Page 29
Procedure Illustration
7) Remove 1 screw and then remove the
electrical cover(see CJ_OP_INV_005).
8) Disconnect the two connectors for
display board(see CJ_OP_INV_005) .
9) Slid the front panel side to side to
release each axis (see CJ_OP_INV_006)
10) Remove one screw and rotate the
display board clockwise. Then take it
out of the clips. (see CJ_OP_INV_007).
CJ_OP_INV_005
CJ_OP_INV_006
CJ_OP_INV_007
Note: This section is for reference only. Actual unit appearance may vary.
To Next Page
Loading...
