To Next PageTo Next PageHow to fix a Carrier Air Conditioner when the engine will not crank?
If your Carrier Air Conditioner's engine won't crank, start by checking the 15A fuse on the generator control panel and replace it if it's blown. Also, inspect the battery cables for looseness, corrosion, or defects; tighten, clean, or replace them as needed. Finally, ensure the battery is adequately charged; charge or replace it if necessary.
What to do if Carrier Air Conditioner engine cranks but will not start?
If the engine cranks but your Carrier Air Conditioner won't start, begin by ensuring that the unit has fuel. Then, inspect the spark plugs; clean, re-gap, or replace them if they are defective. Finally, reset the valve lash.
Why does my Carrier Air Conditioner engine start hard and run rough?
If your Carrier Air Conditioner's engine starts hard and runs roughly, check and replace the air cleaner. Also, inspect the spark plugs and clean, re-gap, or replace them if defective. Set the fuel regulator and confirm the fuel pressure is at (0.40-0.5 psi) for LP, and 5-7” water column (0.18-0.25 psi) for natural gas.
What to do if there is no AC output from Carrier Air Conditioner generator?
If there is no AC output from your Carrier Air Conditioner's generator, check if the main line circuit breaker is open. If it is, reset the circuit breaker to the ON (or closed) position.
General| Type | Inverter |
|---|---|
| Cooling Capacity | 1.5 Ton |
| Cooling Capacity (BTU) | 18000 BTU |
| Energy Efficiency Ratio (EER) | 3.5 |
| Compressor Type | Rotary |
| Indoor Unit Noise Level | 42 dB |
| Power Supply | 220-240V, 50Hz |
| Noise Level (Indoor Unit) | 42 dB |
| Refrigerant | R32 |
Read this manual thoroughly for safe operation and servicing.
Operator's responsibilities for safety checks and maintenance.
Key safety instructions for generator installation, operation, and servicing.
Critical warnings about serious injury or death due to imprudent operation.
Important notices regarding potential personal injury or property damage.
General hazards and precautions related to exhaust, ventilation, and parts.
Warnings and safety precautions for electrical hazards and shock.
Precautions for safe installation and maintenance to prevent fires.
Precautions to prevent fire or explosion from fuel and fumes.
Engine protection system overview.
Pre-start checks for generator installation.
Electrical checks before generator start-up.
Testing generator under full load.
Verifying automatic operation sequence.
Recommended generator break-in procedure.
Initiating automatic transfer operation.
Sequence of automatic generator operation.
Manual transfer of power sources.
Transferring back to utility power.
Checking engine oil level.
Changing engine oil procedure.
Generator service schedule.
Troubleshooting guide for common issues.
Carrier Two-Year Limited Generator Warranty.
