be done around an operating unit, stand on an 
insulated, dry surface to reduce shock hazard.
• Do not handle any kind of electrical device while 
standing in water, while barefoot, or while hands or 
feet are wet. DANGEROUS ELECTRICAL SHOCK 
MAY RESULT.
• The National Electrical Code (NEC) requires the 
frame and external electrically conductive parts of 
the generator to be connected to an approved earth 
ground. Local electrical codes also may require 
proper grounding of the generator electrical sys-
tem.
• After installing this home standby electrical sys-
tem, the generator may crank and start at any time 
without warning. When this occurs, load circuits 
are transferred to the STANDBY (GENERATOR) 
power source. To prevent possible injury if such a 
start and transfer occur, always set the generator’s 
AUTO/OFF/MANUAL switch to its OFF position 
before working on equipment and remove the 7.5A 
and 15A fuses from the generator control panel.
•  In case of accident caused by electric shock, imme-
diately shut down the source of electrical power. 
If this is not possible, attempt to free the victim 
from the live conductor. AVOID DIRECT CONTACT 
WITH THE VICTIM. Use a nonconducting imple-
ment, such as a dry rope or board, to free the vic-
tim from the live conductor. If the victim is uncon-
scious, apply first aid and get immediate medical 
help.
• Never wear jewelry when working on this equip-
ment. Jewelry can conduct electricity resulting in 
electric shock, or may get caught in moving com-
ponents causing injury.
 FIRE HAZARDS 
• For fire safety, the generator must be installed 
and maintained properly. Installation always must 
comply with applicable codes, standards, laws 
and regulations. Adhere strictly to local, state and 
national electrical and building codes. Comply 
with regulations the Occupational Safety and 
Health Administration (OSHA) has established. 
Also, ensure that the generator is installed in 
accordance with the manufacturer’s instructions 
and recommendations. Following proper installa-
tion, do nothing that might alter a safe installation 
and render the unit in noncompliance with the 
aforementioned codes, standards, laws and regula-
tions.
• Keep a fire extinguisher near the generator at all 
times. Extinguishers rated “ABC” by the National 
Fire Protection Association are appropriate for 
use on the standby electric system. Keep the extin-
guisher properly charged and be familiar with its 
use. Consult the local fire department with any 
questions pertaining to fire extinguishers.
 EXPLOSION HAZARDS 
• Do not smoke around the generator. Wipe up any 
fuel or oil spills immediately. Ensure that no com-
bustible materials are left in the generator com-
partment, or on or near the generator, as FIRE or 
EXPLOSION may result. Keep the area surround-
ing the generator clean and free from debris.
•  Gaseous fluids such as natural gas and liquid pro-
pane (LP) gas are extremely EXPLOSIVE. Install 
the fuel supply system according to applicable 
fuel-gas codes. Before placing the home standby 
electric system into service, fuel system lines must 
be properly purged and leak tested according to 
applicable code. After installation, inspect the fuel 
system periodically for leaks. No leakage is permit-
ted.
STANDARDS INDEX
In the absence of pertinent standards, codes, regu-
lations and laws, the published information listed 
below may be used as installation guide for this 
equipment.
1. NFPA No. 37, STATIONARY COMBUSTION 
ENGINES AND GAS TURBINES, available from 
the National Fire Protection Association, 470 
Atlantic Avenue, Boston, MA 02210.
2. NFPA No. 76A, ESSENTIAL ELECTRICAL 
SYSTEMS FOR HEALTH CARE FACILITIES, 
available same as Item 1.
3.  NFPA No. 54, NATIONAL FUEL GAS CODE, 
available same as Item 1. 
4.  NFPA No. 58, AMERICAN NATIONAL STANDARD 
FOR STORAGE AND HANDLING OF LIQUEFIED 
PETROLEUM GAS, available same as Item 1.
5.  NFPA No. 70, NFPA HANDBOOK OF NATIONAL 
ELECTRIC CODE, available same as Item 1.
6.  Article X, NATIONAL BUILDING CODE, available 
from the American Insurance Association, 85 
John Street, New York, N.Y. 10038.
7. AGRICULTURAL WIRING HANDBOOK, avail-
able from the Food and Energy Council, 909 
University Avenue, Columbia, MO 65201.
8. ASAE EP-3634, INSTALLATION AND 
MAINTENANCE OF FARM STANDBY ELECTRICAL 
SYSTEMS, available from the American Society 
of Agricultural Engineers, 2950 Niles Road, St. 
Joseph, MI 49085.
9.  NFPA No. 30, FLAMMABLE AND COMBUSTIBLE 
LIQUIDS CODE, available same as Item 1.
IMPORTANT SAFETY INSTRUCTIONS
15 kW Generator
 3