Carrier 48LC - Page 57

57
10. Setting Digital Inputs:
a. Press the Back key until the following display
appears --
3---** Reference / Ramps
4--- ** Limits / Warnings
b. Press B(Down Arrow) once, the following
display appears --
4--- ** Limits / Warnings
5 --- * * D i g i t a l I n / O u t
c. Press OK, the following display appears --
5 --- 0 * D i g i t a l I / O m o d e
5--- 1* Digital Inputs
d. Press B(Down Arrow) once to move the high-
light to the bottom row and then press OK.The
following display appears --
5-10 Terminal 18 Digital In…
[8] Start
e. Press B(Down Arrow) again. The following
display appears --
5-11 Terminal 19 Digital In…
[16] Preset ref bit 0
f. Press B(Down Arrow) again. The following
display appears --
5-12 Terminal 27 Digital In…
[17] Preset ref bit 1
g. Press B(Down Arrow) again. The following
display appears --
5-13 Terminal 29 Digital In…
[18] Preset ref bit 2
NOTE: By pressing OK the number in the bracket can be
changed until the desired number appears. Press OK again
to set the selected value.
11. Setting Reset Mode and RFI Filter:
a. Press the Back key until the following display
appears --
0 --- * * O p e r a t i o n / D i s p l a y
1---* * Load and Motor
b. Press B(Down Arrow) until the following display
appears --
1 3 --- * * S m a r t L o g i c
1 4 --- * * S p e c i a l F u n c t i o n s
c. Press OK, the following display appears --
14---0* Inverter Switching
14---1* Mains On/Off
d. Press B(Down Arrow) twice. The following
display appears --
14---1* Mains On/Off
14--- 2* Reset Functions
e. Press OK, the following display appears --
14-20 Reset Mode
[0] Manual reset
f. Press OK to highlight the number in the bracket.
g. Use the Y and B (Up and Down Arrow)keys
to change the number to 3 for 3 automatic resets
andthenpressOK. The display changes to --
14-20 Reset Mode
[3] Automatic reset x 3
h. Press B(Down Arrow) once, the following
display appears --
14-21 Automatic Restart T…
10s
i. Press OK to highlight the number of seconds
and use the Y and B (Up and Down Arrow)
keys to select 600 seconds. Press OK again to
set the selected value.
j. Press the Back key once, the following display
appears --
14---1* Mains On/Off
14--- 2* Reset Functions
k. Press B(Down Arrow) twice, the following
display appears --
14---4* Energy Optimising
14---5* Environment
l. Press OK, the following display appears --
14-50 RFI Filter
[1] On
m. Press OK to highlight the number in the bracket
and use the Y and B (Up and Down Arrow)
keys to select [0]. Press OK again to set the
selected value.
12. To Complete Reprogramming:
a. Press the Auto On key before disconnecting the
VFD Remote Keypad from the variable
frequency drive.
48HC48LC