61
Smoke Detectors
Smoke detectors are available as factory--installed options on
48LC models. Smoke detectors may be specified for Supply
Air only or for Return Air without or with economizer or in
combination of Supply Air and Return Air. All components
necessary for operation are factory--provided and mounted.
The unit is factory--configured for immediate smoke detector
shutdown operation; additional wiring or modifications to
the Integrated Staging Control (ISC) board may be necessary
to complete the unit and smoke detector configuration to
meet project requirements.
Units equipped with factory--optional Return Air smoke
detectors require a relocation of the sensor module at unit
installation. See Fig. 60 for the as shipped location.
Completing Installation of Return Air Smoke Sensor:
1. Unscrew the two screws holding the Return Air
Smoke Detector assembly. See Fig. 61, Step 1. Save
the screws.
2. Turn the assembly 90 and then rotate end to end.
Make sure that the elbow fitting is pointing down. See
Fig. 61, Step 2.
3. Screw the sensor and detector plate into its operating
position using screws from Step 1. See Fig. 61, Step 3.
4. Connect the flexible tube on the sampling inlet to the
sampling tube on the basepan.
Return Air
Smoke Detector
(as shipped)
C12282
Fig. 60 -- Return Air Smoke Detector, Shipping Position
Additional Application Data —
Refer to Catalog No. HKRNKA--1XA for discussions on
additional control features of these smoke detectors
including multiple unit coordination.
Step 1 Step 2 Step 3
C12283
Fig. 61 -- Completing Installation of Return Air Smoke Sensor
48LC
To Next Page
Loading...
