62
Step 13 — Adjust Factory--Installed Options
Smoke Detectors —
Smoke detector(s) will be connected at the Integrated
Staging Control (ISC) board, at terminals marked “Smoke
Shutdown”. Remove jumper JMP 3 when ready to
energize unit.
Step 14 — Install Accessories
Available field installed accessories include:
Curb
Thru--base connection kit (must be installed before unit
is set on curb)
EconoMi$er X (with control)
Power Exhaust
Outdoor enthalpy sensor
Differential enthalpy sensor
CO
2
sensor
Louvered hail guard
Phase monitor control
Refer to separate installation instructions for information
on installing these accessories.
Pre--Start and Start--Up
—
This completes the mechanical installation of the unit.
Refer to the unit’s Service Manual for detailed Pre--Start
and Start--Up instructions. Download the latest versions
from HVAC Partners (www.hvacpartners.com).
Copyright 2013 Carrier Corp. D 7310 W. Morris St. D Indianapolis, IN 46231 Edition Date: 10/13
Manufacturer res er ves the right to change, at any time, specifications and designs without notice and without obligations.
C a t a l o g N o : 4 8 L C --- 7 --- 0 2 S I
R e p l a ce s : 4 8 L C --- 7 --- 0 1 S I
48LC
To Next Page
Loading...
