Carrier AquaSnap 30AWH-R - 2.4. Current setpoint setting

8
2.4. Currentsetpointsetting
Herearetwosetpointcontrols:(Refertothetechnicalparameterconguration,item1fordetailedsettings)
j Water setpoint control; the unit is controlled by water setpoint;
k Air setpoint control: the unit is controlled by the air setpoint, and it requests to install the wired controller in the room.
There is an IAT sensor built inside the wired controller to detect the room temperature. Here are the steps to change the
water setpoint control:
j While in standby mode or operating cooling/heating mode:
i. First press “up” or “down” button to change the setting of LWT;
 ii.Thenpresstheconrmbuttonorwaitfor5swithoutpressinganybuttontoDHWtemperaturesetting.Next,press
the “up” or “down” button to change the setting of DHW.
k While operating in DHW mode:
i. First press the “up” or “down” button to change the temperature of DHW;
 ii.Presstheconrmbuttonorwaitfor5swithoutpressinganybuttontoenterthesettingvalueofLWT.Next,press
the “up” or “down” button to change the setting of LWT.
2. User operation