GROUNDING INSTRUCTIONS/SERIAL RATING PLATES 7
GROUNDING INSTRUCTIONS
This appliance is equipped with a three-prong
(grounding) plug for your protection against shock
hazards.The appliance should be plugged directly into
a properly grounded three-prong receptacle.
Where a two-prong wall receptacle is encountered, it
must be replaced with a properly grounded three
prong receptacle in accordance with the National
Electrical Code and local codes and ordinances. The
work must be done by a licensed electrician.
IMPORTANT
Do not under any circumstances cut or remove
the round grounding prong from the equipment plug.
WARNING
Consult a licensed electrician if you have any doubt about the grounding
of your wall receptacle. Only a licensed electrician can determine the
polarization of your wall receptacle. Only a properly installed three-pronged
wall receptacle assures the proper polarization with the equipment plug.
SERIAL RATING PLATES
Serial Number Rating Plates on each vertical cabinet
are located on the inside upper left hand corner. This
plate contains all technical data necessary to the oper-
ation of the cabinet. Warranty administration is based
on the serial number as printed on the rating plate.
To Next Page
Loading...
