Carrier Connect 33CONNECTSTAT43

To Next Page

To Previous Page

Using the Carrier® Connect™ Wi-Fi Thermostat's screens

• Space Temperature — The center portion of the screen displays the sensed space temperature, in whole

numbers only. Fahrenheit is the default scale but you can change to Celsius in SYSTEM SETTINGS. See To

configure advanced System Settings (page 14).

• Equipment Status — The icon displays the current Mode selected. If the selected Mode icon is flashing, the

equipment associated with the current Mode is operating.

○ If you tap the Fan mode/operation icons, the screen switches to the FAN screen.

○ If you tap the Heat or Cool icons, the screen switches to the MODE screen.

SETPOINT

Use this screen to view, adjust, or hold heat and cool setpoints. Use the wheels to adjust setpoints. Drag a wheel

up or down or tap the top or bottom of the wheel to increase or decrease by 1 increment.

There are 2 different buttons that can appear in the center of this screen. Press to switch buttons and functions.

• OCCUPIED/UNOCCUPIED button

• PLAY button allows you to either play (use as is) or alter the program schedule

• Text on top of the button is the current state

• Text beneath the button is what will happen when you press the button

If the schedule is running, the Occupancy button and the text display whether the schedule is currently running

OCCUPIED or UNOCCUPIED setpoints. Press the button to switch heat and/or cool setpoints between Occupied

and Unoccupied settings and then the Occupancy button changes to the PLAY button.

When the schedule is not running, the text above the Play button says OCCUPIED if the heat and cool setpoints

are the same as the OCCUPIED setpoints or UNOCCUPIED if the heat and cool setpoints match the Unoccupied

setpoints. If neither is true, HOLD displays. When the schedule is paused, the remaining hold time shows in the

lower right corner.

Carrier Connect 33CONNECTSTAT43 - Setpoint