Carrier Connect 33CONNECTSTAT43 - Page 43

Troubleshooting
33CONNECTSTAT43 ©2022 Carrier.
Installation Guide All rights reserved.
39
Faults
Condition
HUM TEMP SENSOR LOW
Humidity sensor temperature = 0
NOTE Displayed only if using humidity temperature as a backup source during
a fault condition with the primary temperature sensor.
ID TEMP RANGE HIGH
Indoor Temp above cooling setpoint plus MAX SETPOINT ERROR
ID TEMP RANGE LOW
Indoor Temp below heat setpoint minus MAX SETPOINT ERROR
HUM SENSOR FAILURE
Any of the following:
• Humidity sensor timed out
• Humidity reading is > 99%
• Humidity reading is 0
HUMIDITY RANGE HIGH
Humidity reading is > 90%
HUMIDITY RANGE LOW
Humidity reading is < 10%
OUTDOOR SENSOR FAILURE
OD temp > 127 or < -60
NOT CONNECTED TO SERVER
Not connected to Ayla server
NOT CONNECTED TO ROUTER
Router signal strength is 0 = no bars = not connected
WI-FI HARDWARE FAULT
Communications error occurred with Wi-Fi module (resets after valid message
received)
ECONOMIZER FAULT
Contact closure on remote sensor input, as determined by Economizer
LOCKOUT
User has entered incorrect pin 5 consecutive times