Installation & Commissioning Manual:
Neos 100S, 20X, 30S, 35X, 40X, 50X
62-11165 Rev D
®
20
Compressor Mounting
Install the road compressor on the vehicle following the bracket manufacturer’s
installation instructions.
Connect the high pressure line (HP) and the larger
suction line (LP).
Install the injection thermostat (BPT) on the compressor
high pressure line using the supplied clamp.
HP
LP
BPT
Make sure the injection thermostat is making
good contact with the high pressure line.
After connecting the injection thermostat terminals,
insulate the injection thermostat body with the
insulating material supplied.
Make electrical connections for the injection thermostat and
the compressor clutch. Place wires in protective split loop.
To Next Page
Loading...