Carrier KJR120 - INSTALLATION METHOD; Wire Connection Procedure

3. INSTALLATION METHOD
4
Fig 3-2
1. Connect the female joint of wires group from the mainboard with the male joint of
connective wires group. (See Fig.3-1)
2. Please connect the other side of connective wires group with the male joint of wires
group leads from wire controller. (See Fig.3-1)
3. Take o the cover of wire controller at the bottom with the screwdriver. (See Fig.3-2)
Installation diagram
Fig 3-1
Mainboard
Connective wires (accessory)