10
FASTEN THE WIRED CONTROLLER BACK PLATE
1. For surface mounting, fasten the back plate on the wall with the 3 screws (M4x20) and plugs
(see Fig. 6).
Back plate
Screws (M4×20)
Fig. 6 - Fasten Back Plate
2. For switch box mounting, fasten the back plate on the switch box with 2 screws (M4x25) and
fasten it on the wall with 1 screw (M4x20) (see Fig. 7).
Back plate
Screws (M4×20)
Fig. 7 - Flush Mounting
NOTE: Place on a flat surface. Be careful not to distort the wire controller’s back plate by
over−tightening the mounting screws.
To Next Page
Loading...
