6
INSTALLATION ACCESSORY
PREPARATION BEFORE INSTALLATION
1. Confirm the following required parts have been supplied (see Table 3).
Table 3—Parts
No. NAME QTY. REMARKS
1
Wired controller
1
2 Installation and owner's manual 1
3
Screws
3 M4X20 (for mounting on the wall)
4 Wall plugs 3 For mounting on the wall
5
Screws
2 M4X25 (for mounting on the switch box)
6 Plastic screw bars 2
For fixing on the switch box
7 Battery 1
8 The connection cable 1 19 feet (6 meters)
9 Adapter Board 1 Required for High Wall 40MAQ/619P*B
10 Display Board 1 Required for High Wall 40MAQ/619P*B
NOTE:
Extension wire available through RCD (Replacement Components). Part Number: 17401204000769.
For 40MHH High Wall follow the instructions on the installation manual of the indoor unit.
2. Prepare the following assemblies on site.
Table 4—Assemblies
No. NAME
QTY. (EMBEDDED
INTO WALL)
SPECIFICATION (ONLY
FOR REFERENCE)
REMARKS
1 Switch box 1
2
Wiring tube (insulating sleeve and
tightening screw)
1
To Next Page
Loading...
