High Wall Type
Owner’s Manual
–13–
6-2. Adjusting Clock
Setting the clock
Before operating the air conditioner, set the clock of
the remote control by following the procedures
given in this section. The clock panel on the remote
control will indicate the time regardless of whether
the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote control
the clock panel will indicate AM 0:00 and will flash.
1 TIMER or button
Press the TIMER or button to set the current
time.
Each press of the TIMER button changes the time in
one minute steps.
Pressing the TIMER button continually changes the
time in ten minute steps.
2 SET button
Press the SET button.
The current time is indicated and the clock starts.
Clock adjusting
1 CLOCK button
Press the CLOCK by tip of a pencil.
The CLOCK display flashes.
2 TIMER or button
Press the TIMER or button to set the current
time.
Each press of the TIMER button changes the time by
one minute.
Pressing the TIMER button continually changes the
time by ten minutes.
3 SET button
Press the SET button.
The current time is indicated and the clock starts.
CLR
SLEEP
SET
TEMP
1
ON
OFF
ON
OFF
SET
SET
CLR
SLEEP
SET
TEMP
1
ON
OFF
ON
OFF
SET
SET
13-EN
+001111053801_00Ta.book Page 13 Friday, January 21, 2011 3:52 PM
To Next Page
Loading...
