Carrier MMK-AP0073H2UL - Wireless Remote Control Operations; Cooling, Heating, and Fan Only Operations; Dry Operation Mode; Automatic Changeover Operation

High Wall Type
Owner’s Manual
–15–
6-5. Wireless Remote
Control
 Cooling/heating/fan only
operation
Start
1 ON/OFF button ( )
Press this button to start the air conditioner.
2 MODE button
Select Cool , Heat , or Fan only .
3 Set temperature button ( )
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4 FAN button
Select one of LOW , LOW
+
,
MED , MED
+
,
HIGH .
• The OPERATION lamp (green) on the
display panel of the indoor unit illuminates. And
operation starts after approximately 3 minutes.
(If FAN ONLY mode is selected, the unit will start
immediately.)
• The : Fan only mode does not control
temperature.
• Fan speed is the same as
HIGH .
Therefore, perform only steps
1, 2 and 4 to
select this mode.
Stop
ON/OFF button ( )
Press this button again to stop the air conditioner.
 Dry operation
Start
1 ON/OFF button ( )
Press this button to start the air conditioner.
2 MODE button
Select DRY .
3 Set temperature button ( )
Set the desired temperature.
• The fan speed display indicates
• The OPERATION lamp (green) on the
display panel of the indoor unit lights, and
operation starts after approximately 3 minutes.
Stop
ON/OFF button ( )
Press this button again to stop the air conditioner.
TEMP
2
4
3
1
TEMP
TEMP
2
3
1
TEMP
15-EN
+001111053801_00Ta.book Page 15 Friday, January 21, 2011 3:52 PM