High Wall Type
Owner’s Manual
–21–
CAUTION
• The FIX and SWING buttons will be disabled
when the air conditioner is not in operation
(including when the ON timer is set).
• Do not operate the air conditioner for long
hours with the airflow direction set downward
during the cooling or dry operation.
Otherwise, condensation may occur on the
surface of the vertical airflow louver and cause
dew dripping.
• Do not move the vertical airflow louver
manually. Always use the FIX button.
If the louver is moved manually, it may
malfunction during operation.
If the louver malfunctions, stop the air
conditioner once, and restart.
• When the air conditioner is started immediately
after it was stopped, the vertical airflow louver
might not move for 10 seconds or so.
• Louver operation is limited when performing
group control. (Refer to “7 Limited Operation by
Group Control”)
Adjust the horizontal airflow
Preparation
• Take hold of the lever on the horizontal airflow
louver and move them to adjust the airflow
direction as required.
• The airflow can be adjusted at the left, and right
locations of the louver.
21-EN
+001111053801_00Ta.book Page 21 Friday, January 21, 2011 3:52 PM
To Next Page
Loading...
Need help?
General
