Carrier NUI 33AW-CS2 - Changing User Settings; User Configuration Default Reset; Advanced Programming Options

12
Advanced Programming Options
User conguration default reset
Procedure for Changing the User Parameter settings to
Default values is given below.
Press simultaneously home ( 1.
) and away ( )
buttons at a time for 10 seconds to enter into the user
conguration mode. When this setting is rst selected,
999 will be displayed in the time display area and an
initial value of 10 will be displayed in the temperature
display area.
Press and hold the down button. When the counter 2.
reaches zero, “Fd” will be displayed in the temperature
display area. This represents factory defaults are in
progress. Upon successful completion of restoring
defaults to EEPROM, the NUI will then force a reset.
your desired value, which should be within the range
specied for that parameter and specied icon will be
displayed for that particular parameter.
Press the mode (M) button to save settings and 5.
enable the next parameter to be changed. The
parameter number will be ashing.
Press up and down button to go to the next 6.
parameter. (If the current display is at parameter
number).
You can program all your parameters by following 7.
the same procedure. Once you completed, press OK
or zone (
) button to save your settings and will
return to the normal display screen.
Close the lid.8.
Note: Refer to parameters table in the main unit
documentation for more details.
English