Carrier NUI 33AW-CS2 - Installer Configuration Mode; Installer Configuration Default Reset

17
Installation
Installer conguration default reset
Press zone ( ) and hold ( ) buttons at a time for 10
seconds to enter into the installer conguration mode.
When this setting is rst selected, 899 shall be displayed
in the temperature zone and an initial value of 10 shall be
displayed in the time-zone of the display. Press and hold
the down button. When the counter reaches zero, "Fd" shall
be displayed in the temperature-zone of the display. This
represents factory defaults are in progress. Upon successful
completion of restoring defaults to EEPROM, the NUI shall
than force a reset.
To Enter the Installer Conguration Mode
Press zone (
) and hold ( ) buttons simultaneously
for 3 seconds, the parameter number will be ashing on
the timing-zone and parameter value will be displayed in
temperature-zone of the display.
To modify parameters value, follow steps 3 to 8 of paragraph
"Changing user settings".
Parameter number (ref table 1)
3 sec
English