Carrier NUI 33AW-CS2 - To Change the Factory Settings; Changing the Temperature Time Periods

7
Programming the Control
To change the factory settings
Press and hold the comfort button 1.
(
or or ) to be changed for about ve
seconds. The set temperature along with the symbol
heat (
) or cool ( ) or domestic water ( ) will
ash.
Select the desired zone by pressing the zone ( 2.
)
button repeatedly.
If zone 1 or 2 is selected, press the mode (M) button 3.
to switch between heat (
) and cool ( ).
Press the up or down button on the right side of 4.
the display until you reach the desired temperature
setting for the current mode of operation. At this
moment the triangle icon (
) above the pressed
comfort button (
) will start ashing.
Press the up or down button on the right side of 5.
the display until you reach the desired temperature
setting.
Pressing one of the other two Touch 'N' Go button, 6.
item 4 to 5 can be repeated.
If needed select a dierent zone and repeat steps 3 7.
to 6.
Press OK button to conrm changes and exit from the 8.
Comfort change mode.
Changing the temperature time periods
After you have set temperature settings for home, away and
sleep, you can program the time of day you want to use for
those temperature settings.
Time ranges are called periods; zone 1 and zone 2 have
maximum 6 periods; zone 3 has maximum 4 periods.
Periods are identied on the display as P1, P2, P3, P4, P5
and P6.
The thermostat has preset periods (see below), but you can
change these to t your lifestyle.
To select the number of periods, refer to the (user)
parameters table in the unit documentation.
Period
Period Start Time
Zone 1 / Zone 2 Zone 3
P1 6:00 6:00
P2 8:00 8:00
P3 12:00 18:00
P4 14:00 24:00
P5 18:00 Not available
P6 22:00 Not available
Note: zone 1 and zone 2 have the same time periods.
English