62-11491 6
STARTING UNIT - ENGINE/ROAD OPERATION
1. Place the unit RUN/STOP switch in the “RUN” position.
2. Place the I/O switch in the “I” position.
3. Place the desired compartment switch(es) in the “ON (I)” position.
4. If the unit was previously used in Standby, press the ROAD key.
Under normal circumstances this is all that is required to start the unit.
The unit will then perform a complete diagnostic check on the
microprocessor controller, pre-heat for the required amount of time based
on the engine temperature and start automatically.
Complete the Pre-Trip Inspection as described in a previous section.
BOX TEMPERATURE
AUTO START/STOP
I
UNIT DATA
PRETRIP
ALARM/FAULT
STANDBYBUZZER OFF
MAN
DEFROST
CITY
SPEED
ROAD
FUNCTION
ENTER
SETPOINT
O
i
--20 35° F
COMPARTMENT 1 COMPARTMENT 2 COMPARTMENT 3
To Next Page
Loading...
