62-11491 12
CHANGING SETPOINT
Settings for C1 and C2 will alternate every 5 seconds. Wait until the
desired compartment is displayed and then perform the following:
1. Press the UP or DOWN arrow keys to increase or decrease the dis-
played setpoint.
2. Press the ENTER key when the desired setpoint is displayed to
lock in the new setpoint.
3. A new setpoint will flash and then return to the original setpoint if
the ENTER key is not pressed within 5 seconds.
Setpoints of -22°F to +89°F (-30°C to +32°C) may be entered via the
keypad. The controller always retains the last entered setpoint in memory.
If no setpoint is in memory (i.e. on initial startup), the controller will lock
out the run relay and flash “SP” on the left hand display until a valid
setpoint is entered. The setpoint may be changed up or down in 1°
increments by pressing and releasing either the UP ARROW or DOWN
ARROW key.
You cannot change setpoint when unit is in Pretrip or when viewing Unit
Data or Functional Parameters.
BOX TEMPERATURE
AUTO START/STOP
I
UNIT DATA
PRETRIP
ALARM/FAULT
STANDBYBUZZER OFF
MAN
DEFROST
CITY
SPEED
ROAD
FUNCTION
ENTER
SETPOINT
O
i
--20 35° F
COMPARTMENT 1 COMPARTMENT 2 COMPARTMENT 3
To Next Page
Loading...
