Carrier SUPRA 950Mt - Alarm Display and Reset Guide

9 62-11491
START/STOP OPERATION
1. Check if the AUTO-START/STOP indicator is illuminated.
2. If not, press the AUTO-START/STOP toggle key to place the unit in
Start/Stop mode.
3. The AUTO-START/STOP indicator will then be illuminated.
The AUTO-START/STOP key is used to change the operating mode from
“Continuous Run” to “Auto-Start/Stop.” Each push of the key will alternate
the operating modes. The Auto-Start/Stop indicator on the display will
illuminate when Auto-Stop/Start is enabled. If the indicator is not
illuminated, the unit is in the Continuous Run Mode.
Auto-Start/Stop is provided to permit starting or restarting of the diesel-
driven compressor as required. This gives the microprocessor automatic
control of starting and stopping the diesel engine. The main function of
Auto-Start/Stop is to turn off the refrigeration system near the setpoint to
provide a fuel efficient temperature control system and then restart the
engine when needed. Refer to Recommended Transport Temperatures
for guidelines for Auto-Start/Stop and Continuous Run Operation.
BOX TEMPERATURE
AUTO START/STOP
I
UNIT DATA
PRETRIP
ALARM/FAULT
STANDBYBUZZER OFF
MAN
DEFROST
CITY
SPEED
ROAD
FUNCTION
ENTER
SETPOINT
O
i
--20 35° F
COMPARTMENT 1 COMPARTMENT 2 COMPARTMENT 3
OIOIOI
2
1, 3