15 62-11491
FUNCTION CHANGE (CONTINUED)
The following table has columns for Code and English displays. English is
the default setting. Change Functional Parameter to Code to see Code
display format.
Table 1–1 Functional Parameters
CODE ENGLISH DATA
FN0 DEFR Defrost Interval
*FN1 ON CITY SPD Low Speed
*FN1 OFF HIGH SPD High Speed
FN2 OFF T Minimum Off-time
FN3 ON T On-time
FN4 Degrees F or C Temperature Unit °C or °F
FN5 ON TIME STRT Maximum Off-time 30 Min.
FN5 OFF TEMP STRT Temperature Based Restarting
FN6 MOP STD
FN7 ON AUTO OP Auto Start Operation
FN7 OFF MAN OP Manual Start Operation
FN8 T RANGE Out-of-Range Tolerance
Code vs English = Code or English display format
Manual Glow Override = Normal or Add 30 sec
Alarm RST = Alarm Reset Required
Alarm CLR = No Alarm Active
* FN1 is NOT APPLICABLE for 950MT
To Next Page
Loading...
