58 | P a g e
Compressor Reverse Staging
When enabled, the thermostat can go from stage 2 to stage 1 as it approaches
setpoint. This setting allows the compressor to run longer cycles at stage 1 for
greater efficiency. If it is desired that the system not switch back and forth from
stage 1 to stage 2 then back the stage 1 before turning off, this setting should be
disabled.
Default: Disabled
Options: Enabled, Disabled
On Thermostat:
Select Menu > (hold) Service > Installation Settings > Thresholds >
Compressor Configurations > Compressor reverse staging
To Next Page
Loading...
