EasyManua.ls Logo

Carrier Transicold Vector - Safety and Unit Stopping Procedures; General Safety Precautions; Stopping the Unit

Carrier Transicold Vector
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EASY TO
STOP
Stopping
SETPOINT
BOX TEMPERATURE
START/RUN
STOP
1
0
STANDBY
ENGINE
LANGUAGE
CONTINUOUS
RUN
START-STOPALARMDEFROSTCOOLHEAT
MANUAL
DEFROST
ALARM LIST
START-STOP
CONTINUOUS
SELECT
=
!
TRIP
START
FUNCTION
CHANGE
DATAPRETRIP
Place RUN / STOP switch to STOP to stop
unit.
1
1
FOR YOUR
PROTECTION
Safety
Your CARRIER product has been designed to meet all
European Safety requirements.
Please take notice of all stickers that have been placed on
this product for your safety.They are for your PROTECTION !
Beware of HIGH VOLTAGE (up to 700V) supplied by the
generator as the unit may start automatically. Before servi-
cing unit, make sure the RUN/STOP switch is in STOP position
and disconnect the negative battery cable.
Pacemaker holders must stay clear of the unit while operating
as the power generator supplies HIGH VOLTAGE.
Never dis-assemble the generator
HIGH MAGNETIC FIELD INSIDE.
The refrigerant contained in the refrigeration system
of your unit can cause frosbite, severe burns, or blind-
ness when in direct contact with the skin or eyes.
Replace cover after servicing battery to insure protection of
battery and terminals.
Disconnect battery before doing any electrical welding on unit or
trailer. This unit has a negative ground system.Do not reverse polarity.
Reverse polarity will cause immediate failure of electrical system.
Top up coolant into recovery bottle only.
Fill empty radiator through filler neck slowly to avoid air
entrapment.
Remove filler cap slowly.
Unit may start automatically.
Beware of fan blades and pulleys.
Beware of electric heaters.

Related product manuals