Carrier Transicold Vector - Defrost and Continuous Run Modes; Manual Defrost Procedure; Continuous Run Mode

EASY TO
START
Continuous Run
SETPOINT
BOX TEMPERATURE
START/RUN
STOP
1
0
STANDBY
ENGINE
LANGUAGE
CONTINUOUS
RUN
START-STOPALARMDEFROSTCOOLHEAT
MANUAL
DEFROST
ALARM LIST
START-STOP
CONTINUOUS
SELECT
=
!
Place RUN/STOP switch
in RUN position.
Verify that “CONTINUOUS RUN MODE
SELECTED” is displayed on the message
center and that the CONTINUOUS RUN
light is illuminated.
Press the START-STOP/CONTINUOUS key
until the CONTINUOUS RUN light on the
controller illuminates.
EASY TO
SELECT
Manual Defrost
SETPOINT
BOX TEMPERATURE
START/RUN
STOP
1
0
STANDBY
ENGINE
LANGUAGE
CONTINUOUS
RUN
START-STOPALARMDEFROSTCOOLHEAT
MANUAL
DEFROST
ALARM LIST
START-STOP
CONTINUOUS
SELECT
=
!
Press the MANUAL DEFROST key. The
DEFROST light will come on and the
message center will display “DEFROST
CYCLE STARTED” for 5 seconds or flash
“CANNOT START DEFROST CYCLE” for 5
seconds.
Unit will not defrost if box temperature
is above +4°C.
DEFROST CYCLE STARTED
1
1
CONTINUOUS RUN MODE SELECTED
1
1
2
2
3
3