Carrier Transicold Vector - Standby Operation with LogiCOLD; LogiCOLD Control System Overview

Display
KEYPAD
The microprocessor “LogiCOLD” controls incorporated into
VECTOR are the most reliable control system available.
LogiCOLD is also designed to be the easiest to use.
A message center indicates clear instructions and prompts
the driver through each operation. The choice of
8 languages (Danish, Dutch, English, French, German,
Italian, Russian, Spanish) ensures LogiCOLD user-friendly.
LogiCOLD allows minimal input to obtain maximum
output, a true “Set it and forget it” design.
SETPOINT
BOX TEMPERATURE
START/RUN
STOP
1
0
STANDBY
ENGINE
LANGUAGE
CONTINUOUS
RUN
START-STOPALARMDEFROSTCOOLHEAT
MANUAL
DEFROST
ALARM LIST
START-STOP
CONTINUOUS
SELECT
=
!
TRIP
START
FUNCTION
CHANGE
DATAPRETRIP
EASY TO
RUN
Standby Operation
SETPOINT
BOX TEMPERATURE
START/RUN
STOP
1
0
STANDBY
ENGINE
LANGUAGE
CONTINUOUS
RUN
START-STOPALARMDEFROSTCOOLHEAT
MANUAL
DEFROST
ALARM LIST
START-STOP
CONTINUOUS
SELECT
=
!
Connect standby
cable to unit.
To power up the unit, place
the ENGINE / STANDBY
switch to STANDBY.
Place the RUN / STOP switch
to RUN to start unit.
1
1
Mode lights
Language switch
Engine/Standby
switch
Run/Stop
switch
Selectable
lights
Message center
3
3
Enter key
Up and Down
arrow key
2
2
Note : The unit is fitted with a phase detector which inhibits engine
start-up if the phases are reversed. In the latter case an alarm sounds.
Place the RUN/STOP switch in the STOP position. Disconnect the power
plug and switch the phases in the socket using a screwdriver.