EASY TO
CHECK
Pretrip Check
SETPOINT
BOX TEMPERATURE
START/RUN
STOP
1
0
STANDBY
ENGINE
LANGUAGE
CONTINUOUS
RUN
START-STOPALARMDEFROSTCOOLHEAT
MANUAL
DEFROST
ALARM LIST
START-STOP
CONTINUOUS
SELECT
=
!
DATA
Press the SELECT key until PRETRIP
is illuminated.
Verify that the display shows “TEST # 1”.
Press the = key to start PRETRIP.
EASY TO
CHANGE
Function Change
SETPOINT
BOX TEMPERATURE
START/RUN
STOP
1
0
STANDBY
ENGINE
LANGUAGE
CONTINUOUS
RUN
START-STOPALARMDEFROSTCOOLHEAT
MANUAL
DEFROST
ALARM LIST
START-STOP
CONTINUOUS
SELECT
=
!
FUNCTION
CHANGE
Press the SELECT key until FUNCTION
CHANGE is highlighted.The message
“PRESS TO VIEW SETTINGS”will appear.
Press the UP or DOWN ARROW to scroll through
the Function list. ”TO SCROLL THEN = TO
SELECT” will appear.
3
3
To change one of the Functions, bring the Function
you wish to change into the Message Center, and
press = (ENTER) key. “TO SCROLL, THEN = TO SAVE”
will show in the Message Center. Pressing either UPor
DOWN ARROW key will begin to change the Function
setting.The Message Center will flash, indicating that a
change has been made that has not been entered into
memory.
4
4
1
1
2
2
1
1
2
2
3
3
TEST # 1
PRESS TO VIEW SETTINGS
Continue pressing UP or DOWN ARROW key until the
desired value is shown, then press the = (ENTER) key.
The Message Center will stop flashing. The new value is
now in memory.
Note : Unit can be off when you start PRETRIP
Press and hold the = key for 5 seconds
will cancel the PRETRIP.
To Next Page
Loading...
